home design software - design | 3D | materials lists - sales: 1-800-248-0164
SoftPlan 2018 New Features: Interiors
3D Preview
3D Preview added to Draw command.
Built-Up Assemblies
Built-Up assemblies added for Crown Moldings, Base Boards and Chair Rails.
This allows multiple profiles to be added with a single command.
Half Height Walls
Half height walls with a cap material better locate interiors.
5 Comments
I have the same problem aw Mike Roeder. How do I make a half ht. wall and not have the ceiling edge reference the half wall?
Give support a call but if a wall is half height the ceiling would not stop there. The ceiling stops at a full height wall and probably needs to be drawn separately with the ceiling tool.
How do I make a half ht. wall and not have my ceiling edge reference the half wall?
Will the separate components of the built up moldings report as separate in SoftList?
You may have to set up a separate material definition but best check with the support department on that one.
I have the same problem aw Mike Roeder. How do I make a half ht. wall and not have the ceiling edge reference the half wall?
Give support a call but if a wall is half height the ceiling would not stop there. The ceiling stops at a full height wall and probably needs to be drawn separately with the ceiling tool.
How do I make a half ht. wall and not have my ceiling edge reference the half wall?
Will the separate components of the built up moldings report as separate in SoftList?
You may have to set up a separate material definition but best check with the support department on that one.